How To Assemble Sign Standoffs

1.Measure your sign & mark the wall where the wall screws will go - use a level to make sure the sign will be perfectly straight.

2.Drill pilot holes where marked using a drill bit that's slightly smaller than the width of the supplied wall screw.

3.Take your standoff and unscrew the cap from the barrel.

4.Screw the wall screw through the bottom of the barrel and into the pilot hole - do this for all 4 standoffs.

5.Line up your signage with the 4 barrels on the wall so that the holes in your sign are right over the barrels.

6.Screw the caps through the signage and into the barrels - this will secure the sign in place.