Spacers And Standoffs

Spacers and Standoffs are two common types of positioning electronic hardware. Look inside an assembled circuit board, and you will be greeted by a bevy of Standoffs and Spacers, because in the world of Electronic Hardware, they are the standard for connecting and mounting circuit boards, panels, doors, and gears providing sturdy support and alignment.
Both are commonly used to properly position parts within an assembly, to reduce component contact, to elevate stacked sections, to ensure enough room for heat to dissipate, and to separate or create space between two objects. These guys are workhorses!
Standoffs

Standoffs are threaded hollow Hex or Round fasteners that separate and position components while also fastening them together. The standoff hardware screws onto bolts or screws by hand. Also called standoff mounts, these fasteners are commonly used to raise one assembly above the other, such as elevating a circuit board above a surface. They can also be used to extend thread options or as an adapter to join male-threaded parts to female-threaded parts (and vice versa).
Types:
1) Through Internal Threaded Standoffs.
These are Female-Female type also known as hex spacers with internal thread.
2) Male-Female (E.T.) Standoffs
Selection Guide
When designing and choosing a Standoff for your next application, it is easiest to think of standoffs as 3 separate sections; the two threaded ends and the main body. The below guide will help you think through those 3 sections and provide the common information needed for finding the right standoff.
Step 1 – Thread Type
Standoffs are divided into a few different styles and named after the type of threads on each end.
Female-Female Standoffs
These are also referred to as a Threaded Spacer and come with female threads on both ends of the part. This allows for a screw or male standoff to be installed on either side.
In shorter lengths, standoffs will be threaded through the entire part, where longer standoffs are threaded to a minimum thread depth.
Male-Female Standoffs
These have one end with a male thread and the other end has a female thread.
These are excellent for use when stacking circuit boards as each male thread can be installed into the mating part’s female thread.
This quickly reduces the number of fasteners needed in the assembly while also reducing installation time.
Male-Male Standoffs
This has male threads on both ends and are used to connect 2 female threaded components.
These are also commonly utilized as thread adapters to convert a female thread to a male thread.
Male ends can be the same or a different thread for a wider range of applications.
Step 2 – Thread Size
Standoffs are readily available in all common thread sizes, in both inch and metric series. While most commonly found with each end having the same size thread, different thread sizes can be manufactured on specific order.
Step 3 – Body Length
The third part of the standoff once the thread sizes have been determined is the body.
As standoffs are commonly used to separate 2 components, the body of the standoff is what will separate the components.
As each application will require a unique body length, all standoffs come in a wide range of length options.
Parts are machined to a tolerance for a secure and consistent fit.