Why Should You Use Standoff Screw?

You can use several ideas to hang your signage, but, it would not give you a three-dimensional look. Unlike the traditional signages, the standoff comes as a refreshing way to install your signages. As the sign projects out from the wall with the screw mounted hardware, your signage becomes more striking and attention-grabbing. The sign standoff screw allows it to pop out from the wall making it more visible to your visitors.
The best thing about the standoff screws is apart from being eye-catching; it also supports the weighty sign on the wall firmly. You never have to worry about the signage falling due to weak adhesive or tape. The sign standoff is the best choice for the logo signage above the reception desk, for room ID signs, directory signs, and more. It is also a great way to hang an art piece on metal, custom acrylic signs, or a fixed menu in a restaurant.
How Does the Standoff Signage Work?

The complete standoff screw consists of washers, standoff mount, screw, and drywall anchor. When you use one screw, it is not strong enough to hold the signage. Always use more screws to hold the custom sign appropriately for years.
So, place one each at the corner and at the center to strengthen the mounted signs. The pilot holes are a must for this stylish and sophisticated hanging solution. In the pre-drilled holes, place the screws and hang the signage.
For the wide rectangle or square-shaped signs, you’ll need four standoffs each at the corners. You may also place one standoff each at the bottom and the top for added support. If you choose a customized contour cut shape for your signage, you can customize the placement of the screw as per your desire.
For the installation of the customized sign-
Take measurements for drilling the holes
Lightly mark the wall with a pencil
If you have ordered signs with pre-drilled holes, hold it on the wall mark with a pencil for drilling
Maintain the level on the wall for a straight mounted sign
Insert the anchor by drilling a small hole
Place the standoff over the anchor
Drill the screw into the anchor through the hole on the back of the standoff
Between the back of the signage and at the end of the screw, place the plastic washer and hold the holes of the pre-drilled signage
Finally, thread the standoff screw cap into the standoff housing with a second plastic washer on the front side of the signage